Lower Rear Qtr Panel Install

[Shwagy357]

I am restoring everything from the striker post back to the corner post on the passenger side of my 77 bronco. I was wondering how the best way would be for me to weld in both of my qtr panels. I was thinking about welding both qtr panels into one piece and putting in but idont know?

 

[Mr. Kustom]

Start by test fitting the pieces
then trim to fit if need be. then tack them in place before you do any permanet welding.

hopefully that helps getting you going

 

[Flash69]

Do like Mr kustom said then use a lot of clamps to get it right ,then do your welding.That is a lot easier than breaking welds.