drive shafts

[brokenbronco666]

on a 1994 ranger extended cab the drive shaft is split. and in the middel of the two there is a rubber bearing type thing.and it is so warn out that the drive shaft is wobblin around .and makeing the whole truck shake hard core ,is there any i can put a diffrent drive shaft in there to bypass this???

 

[indoz]

on a 1994 ranger extended cab the drive shaft is split. and in the middel of the two there is a rubber bearing type thing.and it is so warn out that the drive shaft is wobblin around .and makeing the whole truck shake hard core ,is there any i can put a diffrent drive shaft in there to bypass this???

[snapback]16241[/snapback]​

Why not replace the rubber bearing type thing? Easier and cheaper

 

[brokenbronco666]

Why not replace the rubber bearing type thing? Easier and cheaper

[snapback]16261[/snapback]​

because when i lift it im going to haft get rid of that thing anyway

 

[operez8862]

on a 1994 ranger extended cab the drive shaft is split. and in the middel of the two there is a rubber bearing type thing.and it is so warn out that the drive shaft is wobblin around .and makeing the whole truck shake hard core ,is there any i can put a diffrent drive shaft in there to bypass this???

[snapback]16241[/snapback]​

that thing is called driveshaft carrier bearing relatively inexpensive you will to remove the entire driveshaft to take it off .oh yes have heat available propane torch will do hope this helps